Engineering Technical Design Jobs

41 were found based on your criteria

  • Fixed-Price – Est. Budget: $6.00 Posted
    Hi, I need someone to create attached diagram into visio 2010. I will send you a very clear image once accepted your quote. I need this done in next 2-3 hours. Thanks
  • Fixed-Price – Est. Budget: $210.00 Posted
    mix power electronics and signal 300x600mm pcb.
  • Fixed-Price – Est. Budget: $25.00 Posted
    Hi All, I'm looking for some help designing a few small PCB layouts. My end goal is to have 4 independent wireless MEMS accelerometer boards that transmit data to a micro-controller board. The micro-controller also will have a bluetooth module so data can be output to a cell phone or laptop. The 3-axis accelerometers will be sampled somewhere in the frequency range of 1-2kHz (to accurately measure vibration). I should note that, as a mechanical engineer, I have minimal ...
  • Fixed-Price – Est. Budget: $1,000.00 Posted
    We are looking for a contractor to help us with simulations for a PCB antenna. HANDS ON EXPERIENCE WITH IE3D IS A MUST. The work includes the following steps: 1. Antenna simulation for free space (Base Design) -- simulate the return loss and radiation pattern and prove that the simulation is consistent with the reference design. DELIVERABLE 1: Charts, graphs, etc showing that the simulation for the Basic Design is consistent with the reference design from the manufacturer and provide the ...
  • Fixed-Price – Est. Budget: $700.00 Posted
    ARCGIS EXPERT FOR capturing a video from google earth. THAT I can get the terrain and sattellite imagery data from google earth and place it in sketchup where i can model the pipes. The google earth video and sketchup animation can be merged together with the pipe layout traveling along its path.
  • Fixed-Price – Est. Budget: $150.00 Posted
    Using the LTC3852 IC and the reference design from the datasheet: Create a schematic and pcb board layout in Eagle for a 5VDC, 10AMP power supply.. Input Voltage: 12VDC Input Connector: 5.5X2.5mm barrel (surface mount) Output: +5VDC @ 10 AMPS Output Connector: Large solder thru holes. Board size up to 75MM X 75MM Single red LED power indicator (0805 SMT) Although this project is a simple reference design duplication, it ...
  • Fixed-Price – Est. Budget: $100.00 Posted
    Looking for some assistance in the design of a Class B power amplifier. This is the final stage in a servo system. The power amplifier drives a motor whose coil resistance is typically less than 2 ohms and around 100 microhenry. The power amplifier is supplied typically with + and - 24V. It works but needs some tuning. So we're looking for someone with circuit simulation experience, and with experience optimizing power amplifier output stages.
  • Fixed-Price – Est. Budget: $700.00 Posted
  • Fixed-Price – Est. Budget: $50.00 Posted
    Looking for someone with engineering background, and physics understanding to work on a task. There are a few issues that we are trying to resolve with physics and concepts from Linear momentum and angular momentum. We have about 1 week to get the task done and implemented into our project. Attached is a worksheet with some physics principles we are looking at to use. Please review them before you apply. As you will need a good physics background to do ...
  • Fixed-Price – Est. Budget: $50.00 Posted
    200 Amp On/Off Switch I am in need of creating a nice on and off switch for a project that I am working on. I need someone who already has existing experiencing working with this type of work. I would like to make an electrical switch that can handle 200 amps of current for an electric vehicle that I am using. I want to be able to mount a switch similar to this item here - ...