Engineering Technical Design Jobs

207 were found based on your criteria

  • Fixed-Price – Est. Budget: $50.00 Posted
    Create a small board (in Eagle) that can be used by PCB manufacturer to make the boards. It uses one AN30888A SSOP16 LED driver and ATTiny85 MCU for PWM. MCU is powered by AN30888. Components will be hand soldered so there is no need for tight tolerances. Some components do not have size specified, use common sense. Schematic is attached. External input is by two buttons and a temperature sensor, so those need some soldering pads. This is just a ...
  • Fixed-Price – Est. Budget: $120.00 Posted
    After Effects and Motion Graphics Designer NEEDED. I need someone to add and make corrections to my Motion Graphic. I have the PowerPoint that explains it step by step. I need this done by March 6 2014. I need someone that is good at After Effects.
  • Fixed-Price – Est. Budget: $40.00 Posted
    Due to the limit access to correct equipment, i'm looking for someone with the correct equipment available to solve these tasks. All tasks are expected to be done, if excellent and detail explanations, reward will be given by the end If any question or doubt, message me.
  • Fixed-Price – Est. Budget: $40.00 Posted
    I have a simple Altium pcb project (schematic with linked PCB) for which I would like to have an equivalent working Eagle project (schematic + pcb, with full forward/back annotation working). I have already exported the pcb from Altium to Eagle, created a library for the parts and manually re-drawn the schematic. But the schematic is not linking yet to the pcb in Eagle. Upon further investigation it seems that the pcb in Eagle has a some unconnected signals, although ...
  • Fixed-Price – Est. Budget: $75.00 Posted
    We require conversion of concept and pdf construction designs into CAD architectural designs. Most of the designs will be for as built residential properties of 2 floors. Requirements will be for GF and FF plans, front and rear elevations and sometimes side elevations. Expected turnaround for these jobs will be maximum 2 days, and we expect competent CAD technicians to do each project within 8 hours max. We can provide 2-3 projects a week. If you are seriously considering regular ...
  • Fixed-Price – Est. Budget: $100.00 Posted
    I need an electronic engineer to design driver for BLDC Motor. Motor is using Hall Sensors. Our input voltage to driver will be wide from 10.5v-28v and the motor is rated at 36v and maximum 1.2A. We need to run motor at maximum 1200rpm and speed control to reduce rpm. You have to design PCB Layout, Schematic and if need programming so you have to do this. You make the Gerber & BOM for production. We need a variable ...
  • Fixed-Price – Est. Budget: $25.00 Posted
    I am looking for someone to assist in developing a set of calculations using the open source mathematics program Maxima(http://maxima.sourceforge.net/) I will give you a set of calculations that you will enter into Maxima. You will be responsible for inputting physics constants, entering in equations, making sure that units match up and are consistent. An understanding of the following is a must: - Basic understanding of physics in particular electromagnetic theory - Calculus - Differential Equations - Familiarity with Numeric ...
loading