ANSYS Jobs

10 were found based on your criteria

  • Fixed-Price – Est. Budget: $100.00 Posted
    I just need the Ansys simulation for my project I need ansys to calculate the lift & drag forces the lift & drag coefficient like in the EXCEL file The simulation must be OPEN CHANNEL FLOW / MULTIPHASE (FLUENT). The depth of sea water is 35 meter. You can check details from attachment
  • Fixed-Price – Est. Budget: $200.00 Posted
    RC beam needs to be modelled using ANSYS using varying cross sections for reinforcement. Subsequently, flexural strength needs to be found out with variation in steel areas.
  • Fixed-Price – Est. Budget: $150.00 Posted
    I'm looking for in mechanical engineer to design and analyze a coaxial gearbox for a helicopter. Engineer has to have experience with designing gearboxes or similar machinery. Here are the requirements: - Design of assembly including gears, shafts, bearings, retaining rings, etc... - Static FEA - Model analysis separate and assembled (natural vibration frequencies) - fatigue analysis of gearbox and shafts, (cycles until component breaks) - Ansys is the preferred software to use I would like to see some examples of previous work. The ...
  • Hourly – Less than 1 week – 30+ hrs/week – Posted
    We are very much interested to get support for the process design of prototype unit. We do have basic information and design in MATHCADD but we would like to get in a detailed review report and correction in our process to get good result by using ASPEN tool along with your expertise knowledge. 1-mass balance 2-energy balance 3-pfd 4-heat duty for reactors 5-analysis for the expected produced oil and fractionation results. 1. FUELS (CRUDE OIL -ie. Mainly Tar content; DEISEL ...
  • Fixed-Price – Est. Budget: $100.00 Posted
    Hello, We need to know the deformation under charge of this piece in several places. Analysis for one piece in a first time , and all the range if results are OK.
  • Hourly – Less than 1 week – 10-30 hrs/week – Posted
    I am looking for a someone to assist with the design of a mountain bike frame and fork. The job will include 3D modelling the frame, assisting with the design of the chainstay yoke and conducting some finite element analysis on the yoke. I will also require a full set of engineering drawings to be sent to the manufacturer. I am looking for a mechanical Engineer with 3D modelling and finite element analysis experience. If you are able to produce ...
  • Hourly – Less than 1 week – 10-30 hrs/week – Posted
    Hellow. I need to construct a chemical reactor using solid works and also model the chemical reaction though time. Temperature , pressure , etc. This can be done by ansys fluent but im not really sure how to do it. The chemical reactor must have a water bath surrounding it. i.e The reactor will be covered by another bigger container, the space between them will conform the water bath. The goal is to be able to predict (THEORETICALLY) how the reaction ...
  • Hourly – Less than 1 week – Less than 10 hrs/week – Posted
    I require changes made to an existing SolidWorks Assembly. (All parts and assembly will be supplied) to do a radiation analysis in ANSYS. Currently the assembly has a solid tube; I need it to be hollow. The circular cylinder (is not Mated properly) and is not being imported into ANSYS. Finally, I require a Shell around the part, properly mated to the existing assembly. (For radiation analysis) Previous SolidWorks experience is a MUST! (Mech Engineers will be preferred!! ) If you ...
loading