Cisco IOS Jobs

26 were found based on your criteria

  • Hourly – Less than 1 week – Less than 10 hrs/week – Posted
    Our network is configured with 6 switches, 3 in each rack -- a Public, private and an IPMI (KVM). This basic task is just trying to get our IPMI on our private network, rather than have to use public ips for each ipmi access point. Looking for experienced, well reviewed applicants to start immediately.
  • Hourly – Less than 1 week – Less than 10 hrs/week – Posted
    I require someone to configure a Vyatta as a DMVPN spoke connected to a cisco IOS DMVPN HUB I only require the tunnel to be active and reachable. routing is not required there are already other active Spokes in the DMVPN scenario however they are cisco IOS the issue has been trying to get the Vyatta to compatibly connect to the Cisco Hub.
  • Hourly – Less than 1 week – Less than 10 hrs/week – Posted
    Hello, We have five Aironet 1600 units to configure for a floor space. The units are new. We would like to have a setup with two SSIDs, as to provide secure and unsecure access. Each SSID will map to a different VLAN. Unsecure will use WPA2 personal with a pre-set key Secure with use our RADIUS server. Based on the SSID the clients connect to, our firewall will provide different levels of access. We would like for you to advise ...
  • Fixed-Price – Est. Budget: $225.00 Posted
    Need a trainer who can teach the following topics (Basics) within a week, with 2 hours of daily class. Presentations and Lab Demonstrations/Practice is a huge plus. Basic of System Administration • Introduction to Operating Systems• Installation and Management of Windows Server• Installation and Management of Linux Box• Storage Management in Windows and Linux Server• User Roles, permissions and file system management• Basic Troubleshooting (Networking, Services, Booting)• Active Directory, Domain Controller Basics• DNS and DHCP server basics• Basic SQL server ...
  • Hourly – Less than 1 month – 10-30 hrs/week – Posted
    I need a CCIE with good technical writing skills to work on parts of a CCNA training manual. I will supply the topics and you supply the content. Please only apply if you already have experience with technical writing. I'll be looking for samples of your past work. I will supply more information upon receiving your application.
  • Fixed-Price – Est. Budget: $50.00 Posted
    I have a Cisco 2801 with ADSL interface (WAN1) and two ethernet interfaces. eth0/0 : LAN eth0/1 : WAN2 (fiber access) WAN1 is used for VPN IPSEC tunnels WAN2 should be configured for internet access.
  • Hourly – Less than 1 week – 10-30 hrs/week – Posted
    I have two offices that I need to configure QOS for. One office has a Cisco ASA 5505 and Cisco SG300 with 4 VLANS. One for Outside, One for Inside, One for a Backup WAN, and One for Voice. I have smart ports enabled on the Cisco SG300 and our Cisco phones are getting put on the Voice VLAN and the workstations are getting put on the Inside VLAN. I want to also enable QOS to put priority on VOIP ...
  • Hourly – Less than 1 week – Less than 10 hrs/week – Posted
    I need immediate assistance with a Cisco 1700 Router connecting to a T1. All the configs I seem to be trying don't appear to be working. I was provided the following information by the carrrier (ips have been edited) IPv4 Address: x.x.x.32/29 LAN/Ethernet/Gateway IP Address: x.x.x.33 Broadcast IP Address: x.x.x.39 Subnet Mask: 255.255.255.248 WAN Link IPv4 Address: x.x.x.4 AR Serial INT ...
loading