Eagle Jobs

11 were found based on your criteria

  • Hourly – Less than 1 week – Less than 10 hrs/week – Posted
    We have the schematics - now we need a 2 layer small pcs routed. Preferably done in eagle like our older generation of test boards. Board size is approx 25 x 25 mm.
  • Fixed-Price – Est. Budget: $50.00 Posted
    Hi, I have a small electronic device that we need some help with reverse-engineering. We will then want to make a similar device but with through hole components. The device only has about 14 components in total. Thanks
  • Fixed-Price – Est. Budget: $100.00 Posted
    Hi, We are looking for someone to help design a board for a Raspberry Pi computer which uses a switch mode power supply it to step down the 12v feed from the car to 5v for use to power a Raspberry Pi. The board will also need functionality to sense when the ignition of the car is on or off. The board you will design will always have a 12v feed into it. When the ignition is turned on - the ...
  • Fixed-Price – Est. Budget: $5.00 Posted
    I have a .brd file that needs to be converted to a Gerber file for prototyping. It is a VERY simple 2 layer circuit. Should only take about 5 minutes to do. Someone with experience can do it quick. The .BRD file was made in Eagle.
  • Fixed-Price – Est. Budget: $20.00 Posted
    I have a simple circuit LED design I need done. I already made it and have photos to show you. I need it designed so I can send it to prototyping and manufacturing. I need this to be as small as possible also. What will have in the circuit? -Round PCB Board cannot be more than 11/16th of an inch round diameter. -4SMD LED 3528 -2 LR44 batteries on top of each other using a double bracket to hold ...
  • Fixed-Price – Est. Budget: $2,100.00 Posted
    Terminal PCB design as per specs. --- Skills: design
  • Hourly – 1 to 3 months – 30+ hrs/week – Posted
    Hi there, We need someone to help work on a PCB design and prototype for an LED product. It's a simple project using a small microcontroller, AAA battery and an LED with certain flashing functions. The main part of the project is to develop the right PCB design to suit our project, and provide us with working samples. Ability to print prototype PCB and working models is needed. Please apply Thanks Jason --- Skills: microcontroller
  • Hourly – More than 6 months – 10-30 hrs/week – Posted
    We are looking for an Electronics Engineer who has experience working with Altium Designer to assist our in house hardware designer engineer with the following ongoing tasks: Source components that meet specified parameters Manage / create component libraries (schematic & PCB) with Altium Designer Perform routing of printed circuit boards based on supplied schematics Develop and Test firmware for 8 and 32 bit micro controllers Candidates with experience in high speed design shall be preferred Strong english written and verbal Please include ...
  • Fixed-Price – Est. Budget: $150.00 Posted
    I have a schematic and pcb layout done in altium i need updated. we are changing the current atmel at32uc3a464s micro to a atmel at32uc3a3128s. differences are the current is bga100, new is bga144. but the micros are both from same series so most pins remain the same. I also want to make 2-3 very minor component changes, ie replace diodes with cheaper/better solution, maybe mosfet ?? the current board is 6 layer, and has no nested vias. the new ...