Eagle Jobs

8 were found based on your criteria

  • Fixed-Price – Est. Budget: $100.00 Posted
    Using the schematic, CAD dimensions and gerber files that will be provided, convert the simple design to Cadsoft Eagle files. Library should include: Devices Package Symbols Final project will include Eagle Schematic, PCB Board Layout and Gerber Files. All components must be properly labeled in schematic and on board. All engineering notes on schematic should be duplicated into Eagle schematics. All part numbers and components must match original schematic. Use of standard electronic symbols and correct part packages required. Neat ...
  • Fixed-Price – Est. Budget: $100.00 Posted
    This job is to create a BRD Eagle file I can use to generate gerber files for PCB mfr. Maximum board size is 9cm x 4.5cm. Two sided PCB, no internal layers. Bottom is mostly GND plane (under LED power drivers). Naturally, needs to be with soldermask layers in Eagle. I do not need schematics, only brd file. It drives up to 5 LED channels. One channel at 3A, 4 channels as 1A. It contains simple input protection, one ...
  • Fixed-Price – Est. Budget: $100.00 Posted
    We need a sensorless motor control by using ic L6230. Please see the attached Datasheet of L6230 and make the schematics design using a microcontroller to control the L6230. And make the programming for microcontroller such as L6230 can be used to drive a BLDC Sensorless motor. Also we need one output signal from MCU before it starts motor such as we can power on external power supply for motor. Also we need one button for Start, Stop, Speed Up ...
  • Fixed-Price – Est. Budget: $40.00 Posted
    I have a simple Altium pcb project (schematic with linked PCB) for which I would like to have an equivalent working Eagle project (schematic + pcb, with full forward/back annotation working). I have already exported the pcb from Altium to Eagle, created a library for the parts and manually re-drawn the schematic. But the schematic is not linking yet to the pcb in Eagle. Upon further investigation it seems that the pcb in Eagle has a some unconnected signals, although ...
  • Fixed-Price – Est. Budget: $100.00 Posted
    I need an electronic engineer to design driver for BLDC Motor. Motor is using Hall Sensors. Our input voltage to driver will be wide from 10.5v-28v and the motor is rated at 36v and maximum 1.2A. We need to run motor at maximum 1200rpm and speed control to reduce rpm. You have to design PCB Layout, Schematic and if need programming so you have to do this. You make the Gerber & BOM for production. We need a variable ...
  • Fixed-Price – Est. Budget: $1,000.00 Posted
    Hello, basically the project is to create the electronics to make a complete daft punk led display like in the video shown below but before you watch it, keep in mind that i am only trying to complete the silver helmet. http://www.youtube.com/watch?v=2SPN2pJThM0 ok here are the specs on it: 1.) the front is a 11x40 led matrix, so that means there are 11 leds going up and 40 going across. and each led is ...
  • Hourly – Less than 1 month – Less than 10 hrs/week – Posted
    Hi, I am about to start a new project based on the xmega processor from Atmel. I require some advise on what processor I should be using for my project and also some initial work on the schematic to get the basic building blocks of the circuit created: PSU for xmega (24v or 12v power source) Xmega + supporting components JTAG interface Then I will also require some advice on driving around 40 bi color LEDs (red/green), plus another 10 ...
loading