Eagle Jobs

8 were found based on your criteria

  • Fixed-Price – Est. Budget: $50.00 Posted
    Hi, I have a small electronic device that we need some help with reverse-engineering. We will then want to make a similar device but with through hole components. The device only has about 14 components in total. Thanks
  • Fixed-Price – Est. Budget: $100.00 Posted
    Hi, We are looking for someone to help design a board for a Raspberry Pi computer which uses a switch mode power supply it to step down the 12v feed from the car to 5v for use to power a Raspberry Pi. The board will also need functionality to sense when the ignition of the car is on or off. The board you will design will always have a 12v feed into it. When the ignition is turned on - the ...
  • Fixed-Price – Est. Budget: $20.00 Posted
    I want something like the one in this video http://www.youtube.com/watch?v=nrLRvdGYvx4 A file I can open up in Eagle and print out to make it. Also a list with links to every component I need to buy to solder onto the board.
  • Fixed-Price – Est. Budget: $5.00 Posted
    I have a .brd file that needs to be converted to a Gerber file for prototyping. It is a VERY simple 2 layer circuit. Should only take about 5 minutes to do. Someone with experience can do it quick. The .BRD file was made in Eagle.
  • Fixed-Price – Est. Budget: $20.00 Posted
    I have a simple circuit LED design I need done. I already made it and have photos to show you. I need it designed so I can send it to prototyping and manufacturing. I need this to be as small as possible also. What will have in the circuit? -Round PCB Board cannot be more than 11/16th of an inch round diameter. -4SMD LED 3528 -2 LR44 batteries on top of each other using a double bracket to hold ...
  • Fixed-Price – Est. Budget: $2,100.00 Posted
    Terminal PCB design as per specs. --- Skills: design
  • Fixed-Price – Est. Budget: $150.00 Posted
    I have a schematic and pcb layout done in altium i need updated. we are changing the current atmel at32uc3a464s micro to a atmel at32uc3a3128s. differences are the current is bga100, new is bga144. but the micros are both from same series so most pins remain the same. I also want to make 2-3 very minor component changes, ie replace diodes with cheaper/better solution, maybe mosfet ?? the current board is 6 layer, and has no nested vias. the new ...
  • Fixed-Price – Est. Budget: $25.00 Posted
    For the most part, the PCBs have already been designed. What I need someone to do is to create a bill of materials from the designs. There are 3 of them. Additionally, I need the PCBs to be "manufacturable" - I think there might have been some mistakes in the original designs. --- Skills: electronics
loading