We are seeking a licensed ELECTRICAL engineer in NY to assist with stamping drawings for permit submission. The primary responsibility will be to review and stamp the electrical plans. Skills required: - Licensed engineer in NY - Proficient in electrical engineering principles - Knowledge of local building codes and regulations

Electrical and lighting plan for the expansion of an RV Park by approximately 35 sites; upgrade existing electrical system (currently 400 A single phase)

Hello, Im in need of PE services for plans and permitting an unsafe structure violation from the city of Miami. I recently bought the property and after a month of ownership I received the violation. I can upload all the documents via email. I will obtain all the photos related to the violation at the dept of unsafe structures tomorrow morning. The violation is for concrete slab behind the home and fencing (I plan to demo and replace initially) and new tankless water heater which falls under plumbing and electrical then finally the bathroom which was remodeled by the previous owner and I planned to remodel but now needs plumbing approval. I have plans to redo work that has been deemed unsafe and in need of repair. Please let me know if you can help rectifying these issues. The survey is 4 months old so under the 6 month requirement. Thank you.

URGENTT PROJECT. The project would be to design and build a PCB device and 3D Printable enclosure that supplies power via POE (power over Ethernet) to equipment and can accept a standard construction equipment battery from a manufacturer such as Dewalt, Ryobi, etc. to provide the power to the attached device. There should be 2 Ethernet ports (an incoming and outgoing ethernet port) supporting 5Gbps and the power draw will be selectable via switch or button. The power will need to conform to the standards for 802.3af (POE), 802.3at (POE+), and 802.3bt (POE++) and include a power meter that shows the amount of battery power remaining. A USB-C port should also be included. The enclosure should be 3D printable.

We need a circuit designed and prototype built of a bare-board audio interface/ADDA converter. Please see attached pdf for details.

I own a 4 unit apartment building in Cincinnati, OH and we're looking to replace 5 panels in the basement (one house panel + 4 main disconnects), and 4 sub-panels (one in each unit). Per my electrician, we need to do a load calculation on the building (currently 200 amp service), and I'd need to submit plan drawings to the IBI before we can start the work. Engineer must be licensed in state of OH because a stamp is needed. Would prefer that engineer is local to Cincinnati and can visit the property Best, Nima

A modification of preexisting gadgets That need expertise and economic thinking .

Need to complete Electrical plans according to City Redlines TI project no CAD need it only calculations

Need a licensed electrical engineer to correct plans for commercial remodeling project in New Mexico. There are some fixes that are required in the drawings to meet code for New Mexico.

This one will need electrical and mechanical engineering. It’s a supermarket interior renovation. A local grocer has taken over operations and wants to renovate the interior. This store will remain open during the renovations, and they are turning some space into a small bakery, kitchen, and new meat department. Also, there will be a new check cashing office on the opposite side of the store. The work will be phased according to the phasing plan. These are design development drawings for now but as the week progresses, I’ll have an updated set. Will also include new lighting changes in the updated plan for next week. I need a licensed electrical engineer in Louisiana.