Closed - This job posting has been filled.
The attached Solidworks 2010 part is Pipe53, which is a cone with Plane1 passing through the cone. There are four pipes coming out of the cone where it meets the Top Plane and Right Plane. I want to be able to adjust the position of the pipes so that they are defined to be centered on a point where Plane1 intersects the cone and the Top and Right Planes. If this is possible, I will be able to adjust the size of the main pipe, the cone that sits on top of it and the size of each of the pipes coming out of it. This device will be needed for different sizes of pipes. I also want a similar structure but without the pipes coming out but only the holes. In this second structure, the holes may be different sizes.