DXF Endpoint errors - Need fixing - DXF or Solidworks file

Closed - This job posting has been filled.

Job Description

I have a DXF file (also Solidworks part file) that needs to be laser cut. The laser cutter has informed me there are end point errors. He has advised me there is about 2 hours work cleaning up these errors to get them ready for the laser cutter.

His message is as follows:

"Too many end pt errors in your program , will need to spend at least an 2 hr to clean up

See below in red and yellow , each circle indicates errors .

Lines need to be a close contour ie : each line needs to be joint with each other .. no gap or double lines or overlaps"

Please refer to the reference image.

Freelancer must supply the .DXF file with errors fixed and suitable for laser cutter to run.

Please contact me if you have any questions.

I can supply .DXF and Solidworks Part file.

Open Attachment