I'm looking for someone to source a manufacturer of an RFID inlay. The specifications are as follows:
Size: Width < 8mm (Ideally 6mm), Length > 5mm, < 30 mm, Height < 1mm
Standard: ISO 14443, 13.56Mhz, chip doesn't matter so much (it needs to be readable by NFC enabled smartphones (MiFare is not an option))
Inlay type: Wet or Dry inlay is fine but must me slightly flexible to wrap around a tube.
Prototyping: Initial prototype cost less than 500$.
MOQ: < 50000 pcs
Read device: Successful accurate read on mobile phones with NFC enabled.
Only apply if you have the following skills:
1) Ability to converse with RFID factories and manufacturers to deliver a spec for the profile.
2) Understanding of RFID technology and experience sourcing RFID inlays for products/projects.
3) You understand what I'm requesting is going to be hard to find and there will only be a few suppliers capable of delivering this.
When you apply for this job, specify the number of hours you think this task will take you and any similar experience you have in this area.