Reverse Engineer PCB & Components and provide Gerber files, BOM, Software, etc.

Reverse Engineer PCB & Components and provide Gerber files, BOM, Software, etc.

Cancelled

Job Description

I have a very simple PCB that I need to have reverse engineered (See attached picture) so that it is ready for production:
-PCB Layout & Design
-Gerber Files
-BOM with Manufacturer Name & PN as well as recommended distributors for that item
-Software
-Basically the requirement here is I need a set of files I can hand to a PCB & Assembly company and have them provide a quote for manufacturing

I am open to through hole components or surface mount or a mix, whichever will provide the lowest total production costs.

Requirements
1) The PCB needs to have the same shape and mounting holes as the original (2 inch x 2 inch PCB with .1875 inch holes on corners 0.1 inch from edge of board on both sides of hole)
2) The Trimmer/Potentiometer & LED need to be in the same location as the original board (Center of trimmer needs to be 0.855 inch from the top of the PCB and centered left to right on the PCB). The trimmer/potentiometer needs to be able to have a short shaft approx 0.5 inch OR approx 1.4 inch (see picture)
3) The LED light needs to be red and 0.54 inch from the bottom of the pcb and centered left to right. The LED contacts should have plastic insulating tubes or some other insulating method on them (see picture). LED stands 0.8 inch off the PCB (to the bottom of the LED light) and approx 1.1 inch to the top of the light (As long as we are close this doesn't have to be exact)
4) Wire colors should stay the same Black, Red, & White (Wire Length is 4 inches) The ends of the wires should be stripped approx 0.5 inch
5) Set of files I can hand to a PCB & Assembly company and have them provide a quote for manufacturing
6) Need to have 2 sample boards made and delivered to Fruitland, ID 83619 USA